Driverless COB Power Connector

The Driverless COB Power Connector has been created to easily add power to all Driverless COB Light Strips. The COB Power Connector is 60.9" in total length with a 2 prong plug and can power up to 165 feet of light strip. The light strip power connector requires silicone compound to ensure a waterproof seal. The power connector cable heads are made to provide a simple slide-in solution for connecting strips and a clear plastic clampdown lid ensures a secure connection.

To Install:

1. Grab a pair of disposable gloves and put them on.
2. CAREFULLY use a sharp blade to remove the silicone on top of the positive and negative terminals on the pieces you wish to connect. Make sure there is no silicone remaining on the pads. Take care to not cut the center phosphate strip or you may expose the light diodes.
3. Slide the long ends of the prong piece into the connector head with the flat side of plastic barrier facing down and the rounded side facing up.
4. After orienting your cut strip to match the positive and negative terminals noted on the connector head, firmly slide the strip into the connector head making sure the flat ends of the prongs touch the tops of the exposed terminal pads.
5. CAREFULLY test your connection. DO NOT touch exposed ends of the strip or connectors. Making contact with 120V may cause serious injury or death.
6. After confirming the connection is successful remove the unit from power.
7. Use silicone compound to cover the exposed terminal pads in the connector head.
8. Attach the clear connector head cover and firmly close until the cover locks into place. We recommend leaving the unit to dry thoroughly for at least 12 hours before handling or installing.